Table of Contents
Advertisement
<Front panel assembly>
Prior to performing the following procedure, remove
the metal cover, the CD changer unit and the front
panel assembly.
Removing the power / CD switch board
1.
Disconnect the card wire from the connector UCW1
on the power / CD switch board.
2.
Remove the five screws A attaching the power / CD
switch board.
Removing the FL display & system control
board
1.
Disconnect the card wire from the connector UCW3,
UCW4, UCW5 and UCW6 on the FL display & system
control board.
2.
Remove the six screws B attaching the FL display &
system control board.
3.
Disconnect the card wire from the connector UCW2
on the FL display & system control board.
Removing the headphone jack board
Prior to performing the following procedure remove
the FL display & system control board.
1.
You can pull out the headphone jack board.
Removing the front key switch board
Prior to performing the following procedure, remove
the FL display & system control board.
1.
Pull out the sound mode knob, volume knob and
subwoofer level knob from front side.
2.
Remove the twelve screws C attaching the front key
switch board.
3.
Remove the front board releasing the two tabs.
4.
Disconnect the card wire from the connector UCW7
on the front key switch board, if needed.
Removing the cassette mechanism
assembly
1.
Disconnect the card wire from the connector on the
mecha. board.
2.
Remove the six screws D attaching the cassette
mechanism assembly.
(See Fig.1)
UCW2
UCW3
UCW4
(See Fig.1)
(See Fig.3)
(See Fig.2 and 3)
UCW7
Mecha.
(See Fig.3)
D
(fixing the earth wire)
Front panel assembly (inner side)
A
B
B
Fig.1
Fig.2
Front panel assembly (inner side)
C
Tab
C
Tab
D
board
Connector
Fig.3
MX-GT700
Power / CD switch board
UCW1
FL display &
system control
board
UCW5
UCW6
Sound mode knob
Volume knob
Subwoofer level knob
Front key switch board
Headphone
jack board
D
Cassette mechanism
assembly
1-9
Hide quick links:
Advertisement
Table of Contents
