Removing The Cd Changer Mechanism Assembly - JVC MX-G950V Service Manual

MX-G950V/MX-G880V
MX-G850V/MX-G750V
Removing the CD changer mechanism
assembly
Prior to performing the following procedure, remove
the metal cover.
1. Disconnect the wire from connector CN705 on the
amplifier board.
2. Remove the plastic rivet attaching the main board to
the front assembly on the right side of the body.
3. Disconnect the card wire from connector CN661 on
the main board.
4. Remove the two screws C on the upper side of the
body and the two screws D on the back of the rear
panel.
5. Pull both the rear panel and the front panel assembly
to the outside, then remove the CD changer
mechanism assembly by lifting the rear part of the
assembly.
REFERENCE: At this point, one card wire on the
underside
assembly is still connected.
6. Disconnect the card wire from connector CN504 on
the inner side of the main board on the right side of
the body. Remove the CD mechanism assembly.
CAUTION: To prevent damage to the CD fitting, be
sure to pull both the rear panel and the
front panel assembly enough to remove
the CD changer mechanism assembly.
1-6
(See Fig.4, 6)
of the CD mechanism
CD changer mechanism assembly
Rear panel
Amplifier board
CN705
C
Main board
CN661
CN504
CD changer mechanism assembly
Plastic rivet
Main board
CN661
CN504
Front panel assembly
(CA-MXG850VU, CA-MXG950VUX)
CD changer mechanism assembly
Plastic rivet
Main board
CN661
CN504
Front panel assembly
(CA-MXG750VUS)
Front panel assembly
Fig.4
Front panel assembly
C
CD changer
mechanism assembly
Rear panel
Fig.5
Rear panel
D
Fig.6
Rear panel
D
Fig.6