Parameters Recommended To Be Set By The User - Mitsubishi FR-E 500 Instruction Manual

4.1.3 Parameters recommended to be set by the user

We recommend the following parameters to be set by the user.
Set them according to the operation specifications, load, etc.
Parameter
Number
1 Maximum frequency
2 Minimum frequency
7 Acceleration time
8 Deceleration time
Electronic thermal O/L
9
relay
14 Load pattern selection
71 Applied motor
73 0-5V/0-10V selection
900 FM terminal calibration
901 AM terminal calibration
Frequency setting voltage
902
bias
Frequency setting voltage
903
gain
Frequency setting current
904
bias
Frequency setting current
905
gain
Name
Used to set the maximum and minimum output
frequencies.
Used to set the acceleration and deceleration
times.
Used to set the current of the electronic
overcurrent protection to protect the motor from
overheat.
Used to select the optimum output characteristics
which match the application and load
characteristics.
Used to set the thermal characteristics of the
electronic overcurrent protection according to the
motor used.
Used to select the specifications of the frequency
setting signal entered across terminal 2-5 to
perform operation with the voltage input signal.
Used to calibrate the meter connected across
terminals FM-SD.
Used to calibrate the meter connected across
terminals AM-5.
Used to set the magnitude (slope) of the output
frequency relative to the frequency setting signal
(0 to 5V, 0 to 10V or 4 to 20mA DC) as desired.
71
PARAMETERS
Application