Mitsubishi FR-E 500 Instruction Manual page 178

(3)Read Pr. 903 and show the current setting of the gain frequency.
(Pr. 902, Pr. 904 and Pr. 905 can also be adjusted similarly.)
"Parameter setting mode
Using the
MODE SET
STOP
FWD
RESET
SET
Most significant
digit flickers.
0 to 9
Current setting of gain frequency
(4)Set a gain frequency in Pr. 903 and show the analog voltage A/D value across
terminals 2-5 in %. (when the frequency is set to 80Hz)
Current setting of
gain frequency
key, choose the "parameter setting mode" as in (2)-1).
MODE
PU
REV
Middle digit
flickers.
×9
times
SET
Hz RUN
A
PU EXT
"Changing the gain
frequency
Hz RUN
A
PU EXT
Press
the set frequency.
"Analog voltage A/D value (%)
across terminals 2-5
In any of the methods in (5) to (7) on the following page,
continue the setting until the analog voltage A/D value
flickers. If you end the setting here, the gain frequency
change will not be reflected.
Least significant
digit flickers.
SET
×3
times
0 to 9
Hz RUN
A MON
PU EXT
to change
Press for 1.5s
SET
Hz RUN
A MON
PU EXT
163
PARAMETERS
SET