Installation Environment; Installation Method; Space Requirements - Epson AcuLaser CX11 Service Manual

EPSON AcuLaser CX11/CX11F

INSTALLATION ENVIRONMENT

Installation Method

1. Remove the hook that join the upper and the lower parts of the package.
2. Pull out the upper part of the package upward.
3. Take out the photoconductor unit and the toner cartridge boxes. *
4. Hold the handles on the bottom of the main unit, lift up the printer, and place
it at the installation location (two persons are required to perform this
operation). If you lift up the printer holding its right-and-left sides, make sure
to support the backside of the LEG with your hands to keep balance.
5. Turn the printer power off.
6. Open the cover A to remove the development unit protective cover, and install
the specified toner cartridge.
7. After installing all the 4-color toner cartridges, close the cover A, lift up the
2
scanner section* , and open the cover B.
8. Turn up the photoconductor insert lever.
9. Insert the photoconductor unit.
10. Close the cover B.
11. Fully extend the paper output extension on the cover B. Be sure to extend the
folded part of the paper output when printing on LGL sized papers.
12. Before scanning LGL sized papers using the ADF, extend the folded part of
the ADF paper feed tray extension, and open the LGL paper output extension.
Note *1: The photoconductor unit for domestic FAX model is packed separately.
*2: As for FAX model, the scanner section is only lifted when the ADF is
closed.
Top
1
100mm
Front
Side
1016 mm
353 mm
manuals4you.com manuals4you.com
Base Model
258mm
300mm
100mm
353mm
Base Model Fax Model
ROD-CLEANER
251mm
Base Model
1005 mm
258 mm 353 mm
1068 mm
Figure 1-3. Space Requirements
Revision B
Fax Model
258mm
300mm
353mm
Leg_008_011RB
ROD-CLEANER
251mm
Leg_008_012RB
Fax Model
258 mm
1068 mm
Leg_008_013RB
28