Fip-P14 Image Not Fixed - Epson AcuLaser CX11 Service Manual

EPSON AcuLaser CX11/CX11F

FIP-P14 Image Not Fixed

Before starting troubleshooting, inspect the feed path of the printer paper. Check the
paper feed path for metal staples, paper clips, paper scraps, and other foreign matter.
Step Check
Check of Paper
1
Load new, dry recommended paper, and
execute a test print.
Is the image printed normally?
Check of print setup mode
2
Is the printer set to a Transfer Voltage suited to
the type of paper in use?
Check of Heat Roll and Pressure Roll
3
Allow FUSER ASSY to cool down
W A R N I N G
before performing work.
Remove FUSER ASSY. (p.415)
Turn the Gear by hand, and inspect Heat Roll
and Pressure Roll.
Are Heat Roll and Pressure Roll scratched or
dirty and damaged?
TROUBLESHOOTING
Problems
The printed image is not sufficiently fixed to
the paper. The image is easily removed by
rubbing it with your fingers.
ESS and possible parts that caused the error
FUSER ASSY
PWBA ESS
PWBA MCU
Yes No
End of procedure Go to Step [2].
Go to Step [3]. Adjust the
Transfer Voltage.
Replace FUSER Go to Step [4].
ASSY. (p.415)
Step Check
Check after replacement of FUSER ASSY
4
Allow FUSER ASSY to cool down
W A R N I N G
before performing work.
Replace FUSER ASSY.
Make a test print of the problem image.
Is the image printed normally?
Check after replacement of PWBA MCU
5
Replace PWBA MCU.
Make a test print of the problem image.
Is the image printed normally?
Printer
Yes
End of procedure Go to Step [5].
(p.415)
End of procedure Replace "ESS and
(p.432)
Revision B
No
possible parts that
caused the error".
269