Epson AcuLaser CX11 Service Manual page 421

EPSON AcuLaser CX11/CX11F
4.2.10.4 MOT ASSY MAG
REMOVAL
1. Remove COVER ASSY LH. (p321)
When performing the following work, the connector of PWBA ESS
C H E C K
P O I N T does not need to be removed.
2. Remove CHASSIS ASSY ESS.
3. Disconnect connector (P/J405) and connector (P/J406) from PWBA MCU.
4. Remove the 3 screws (silver, with flange, 10 mm) fastening MOT ASSY MAG to
the main unit.
5. Remove MOT ASSY MAG from the main unit.
REINSTALLATION
1. Match the boss on MOT ASSY MAG with the hole on the main unit, and attach.
2. Fasten MOT ASSY MAG to the main unit with the 3 screws (silver, with flange,
10 mm).
3. Connect connector (P/J405) and connector (P/J406) to PWBA MCU.
4. Attach CHASSIS ASSY ESS. (p440)
5. Attach COVER ASSY LH. (p321)
Table 4-9. Symptoms when the connector is loose
Connector
Panel Indication
No.
P/J405 Ready
P/J406 Ready
DISASSEMBLY AND ASSEMBLY
(p440)
Error Caused by Connector
Symptom
Disconnection
Entirely Faint
FIP-P17
Normal printing
---
3)
3)
4)
4)
4)
5)
Figure 4-106. Removal of MOT ASSY MAG
Printer
Revision B
Leg_Sec03_102RA
423