Editing Tcp/Ip Options (With Ethernet Encapsulation); Figure 4-4 Remote Node Network Layer Options - ZyXEL Communications Broadband Security Gateway P-312 User Manual

P312 Broadband Security Gateway
4.2

Editing TCP/IP Options (with Ethernet Encapsulation)

Move the cursor to the Edit IP field in Menu 11.1, then press the [SPACE BAR] to toggle and set the
value to Yes. Press [Enter] to open Menu 11.3 - Network Layer Options.
Press Space Bar to Toggle
The next table gives you instructions about configuring remote node network layer options.
Table 4-4
Field
IP Address
Assignment
IP Address
IP Subnet
Mask
Gateway IP
Addr
Network
Address
Translation
Metric
4-6
Menu 11.3 - Remote Node Network Layer Options
IP Address Assignment= Dynamic
IP Address= N/A
IP Subnet Mask= N/A
Gateway IP Addr= N/A
Single User Account= Yes
Metric= N/A
Private= N/A
RIP Direction= None
Version= N/A
Multicast= None
Enter here to CONFIRM or ESC to CANCEL:
Figure 4-4 Remote Node Network Layer Options
Remote Node Network Layer Options Menu Fields
If your ISP did not assign you an explicit IP address, select
Dynamic; otherwise select Static and enter the IP address & subnet
mask in the following fields.
If you have a Static IP Assignment, enter the IP address assigned
to you by your ISP.
If you have a Static IP Assignment, enter the subnet mask
assigned to you.
If you have a Static IP Assignment, enter the gateway IP address
assigned to you.
Use the [SPACE BAR] to toggle between Full Feature, None, SUA
Only. See the NAT chapter for a full discussion on this feature.
This field is valid only for PPTP/ PPPoE encapsulation. The metric
represents the "cost" of transmission for routing purposes. IP routing
uses hop count as the measurement of cost, with a minimum of 1 for
directly connected networks. Enter a number that approximates the
cost for this link. The number need not be precise, but it must be
Description Example
Dynamic
SUA Only
3
Remote Node Setup