Editing Tcp/Ip Options (With Ethernet Encapsulation); Figure 10-5 Menu 11.3: Remote Node Network Layer Options For Ethernet Encapsulation; Table 10-4 Remote Node Network Layer Options Menu Fields - ZyXEL Communications ZYWALL 10W User Manual

10.3 Editing TCP/IP Options (with Ethernet Encapsulation)

Move the cursor to the Edit IP field in menu 11.1, then press [SPACE BAR] to select Yes. Press
[ENTER] to open Menu 11.3 - Network Layer Options.

Figure 10-5 Menu 11.3: Remote Node Network Layer Options for Ethernet Encapsulation

The next table gives you instructions about configuring remote node network layer options.

Table 10-4 Remote Node Network Layer Options Menu Fields

FIELD
IP Address If your ISP did not assign you an explicit IP address, press [SPACE
Assignment BAR] and then [ENTER] to select Dynamic; otherwise select Static
and enter the IP address & subnet mask in the following fields.
IP Address If you have a Static IP Assignment, enter the IP address assigned to
you by your ISP.
IP Subnet If you have a Static IP Assignment, enter the subnet mask assigned to
Mask you.
Gateway IP If you have a Static IP Assignment, enter the gateway IP address
Addr assigned to you.
Network Press [SPACE BAR] and then [ENTER] to select either Full Feature,
None or SUA Only. See the NAT chapter for a full discussion on this
Address
Translation feature.
Remote Node Setup
ZyWALL 10~100 Series Internet Security Gateway
Menu 11.3 - Remote Node Network Layer Options
IP Address Assignment= Dynamic
IP Address= N/A
IP Subnet Mask= N/A
Gateway IP Addr= N/A
Network Address Translation= SUA Only
Metric= N/A
Private= N/A
RIP Direction= None
Version= N/A
Multicast= None
Enter here to CONFIRM or ESC to CANCEL:
DESCRIPTION EXAMPLE
Dynamic
(default)
SUA Only
(default)
10-7