Using The Ftp Command From The Command Line; Example Of Ftp Commands From The Command Line - ZyXEL Communications ZyWALL 10/10 User Manual

To transfer the configuration file to your workstation, follow the procedure
below:
1. Launch the FTP client on your workstation.
2. Type "open" and the IP address of your router. Then type "root" and
SMT password as requested.
3. Locate the 'rom-0' file.
4. Type 'get rom-0' to back up the current System configuration to
your workstation.
For details on FTP commands, please consult the documentation of your FTP
client program. For details on backup using TFTP (note that you must remain
in this menu to back up using TFTP), please see your System manual.

21.2.2 Using the FTP Command from the Command Line

Step 1. Launch the FTP client on your computer.
Step 2. Enter "open", followed by a space and the IP address of your ZyWALL.
Step 3. Press [ENTER] when prompted for a username.
Step 4.
Enter your password as requested (the default is "1234").
Step 5.
Enter "bin" to set transfer mode to binary.
Step 6. Use "get" to transfer files from the ZyWALL to the computer, for example, "get rom-0
config.rom" transfers the configuration file on the ZyWALL to your computer and renames it
"config.rom". See earlier in this chapter for more information on filename conventions.
Step 7. Enter "quit" to exit the FTP prompt.

21.2.3 Example of FTP Commands from the Command Line

Firmware and Configuration File Maintenance
Menu 24.5 - System Maintenance - Backup Configuration
Press ENTER to Exit:
Figure 21-1 Telnet into Menu 24.5
ZyWALL 10/10 II/50 Internet Security Gateway
21-3