Figure 7-5 Menu 11.3 - Remote Node Network Layer Options - ZyXEL Communications ZyWALL 10/10 User Manual

Figure 7-5 Menu 11.3 — Remote Node Network Layer Options
Press Space Bar to Toggle.
The next table gives you instructions about configuring remote node network layer options.
Table 7-5 Remote Node Network Layer Options Menu Fields
FIELD
IP Address If your ISP did not assign you an explicit IP address, select Dynamic;
Assignment otherwise select Static and enter the IP address & subnet mask in
the following fields.
Rem IP If you have a Static IP Assignment, enter the IP address assigned
Address to the remote node.
Rem IP Subnet If you have a Static IP Assignment, enter the subnet mask assigned
Mask to the remote node.
My WAN Addr Some implementations, especially the UNIX derivatives, require the
WAN link to have a separate IP network number from the LAN and
each end must have a unique address within the WAN network
number. If this is the case, enter the IP address assigned to the WAN
port of your ZyWALL.
Note that this is the address assigned to your local ZyWALL, not the
remote router.
Network Use [SPACE BAR] to select either Full Feature, None or SUA Only.
Address See the NAT chapter for a full discussion on this feature.
Translation
Remote Node Setup
Menu 11.3 - Remote Node Network Layer Options
IP Address Assignment= Dynamic
Rem IP Address= N/A
Rem Subnet Mask= N/A
My WAN Addr= 0.0.0.0
Network Address Translation= Full Feature
Metric= 1
Private= No
RIP Direction= None
Version= N/A
Multicast= None
Enter here to CONFIRM or ESC to CANCEL:
DESCRIPTION
ZyWALL 10/10 II/50 Internet Security Gateway
EXAMPLE
Dynamic
192.168.1.1
255.255.255.0
0.0.0.0
SUA Only
7-9