KitchenAid briva KIDS01EK Technical Education page 77

PROBLEM
Poor drying performance.
Lid not opening after cycle.
Lid not latching.
POSSIBLE CAUSE
1. Customer use issues.
2. Heater problem. Check for an
open connection or component
in the heater circuit, an open in
the heater, or a faulty heater
drive circuit on control.
3. Rinse Aid dispenser not dis-
pensing due to a loose har-
ness connection.
4. Open coil on the dispenser
solenoid.
5. Faulty dispenser drive circuit
on control.
1. Faulty lid actuator.
2. Foreign material in plunger
housing.
3. Customer use issues.
1. Lid knob not oriented properly.
2. Foreign material in plunger
housing.
6-9
SOLUTION
I. Recommend using Rinse Aid. Instruct on
how to fill and monitor Rinse Aid.
2. Check all components and connections
in the water heating circuit. Check the
resistances of all connections and com-
ponents between heater and control.
Check the resistance of heater, and its
operation during the Diagnostics cycle.
3. Check the resistance of all connections
between the dispenser and the control.
4. Disconnect the leads and check the re-
sistance of the dispenser coil.
5. Check the operation of the dispenser by
the control during Diagnostics.
1. Check all components and connections
in the lid actuator circuit. Check the re-
sistances of all connections and compo-
nents between the control and the lid
actuator. Check the resistance of the
actuator, and check to see that the lever
from the actuator engages the slider in
the latch assembly.
2. Manually push plunger down and inspect
the area for foreign matter. Remove or
replace the housing as needed.
3. Instruct customer not to leave items on
the lid during the wash cycle.
1. Check that the indicator on the knob
aligns with the indicator on the lid. If
misaligned, repair or replace the lid ac-
tuator assembly.
2. Manually push the plunger down and
inspect the area for foreign matter. Re-
move or replace the housing as needed.