Removing The Dishwasher Lid Actuator - KitchenAid briva KIDS01EK Technical Education

REMOVING THE DISHWASHER LID ACTUATOR

1. Raise the dishwasher lid.
2. Loosen the lid actuator knob setscrew and
remove the knob.
3. Remove the hex nut, e-ring, and flat washer
from the cam shaft, and remove the star
washer, bushing/collar, torsion spring, and
the cam & shaft assembly from the lid.
REASSEMBLY NOTE:
To reassemble the lid actuator:
1. Place the star washer onto the bushing/
collar, and carefully slide the assembly
into the lid opening so that the key in the
assembly fits into the cutout in the bottom
of the lid.
2. Hold the actuator assembly in place, and
slide the flat washer and hex nut over the
bushing and hand tighten the nut.
3. Hold the cam and shaft assembly in the
vertical position with the shaft pointing up,
and slide the torsion spring over the shaft.
4. Rotate the spring until the lower hook
engages the stop inside the cam.
5. Keep the collar engaged with the spring
and rotate the collar counterclockwise until
the collar drops into position on the cam.
The actuator assembly must be held to-
gether to keep the spring from unwinding.
When properly assembled, the cam and
shaft can be manually rotated 90°, and the
spring will return it to its original position.
6. Make sure that the hex nut is far enough
down onto the bushing to fully expose the
e-ring slot, and snap the e-ring into place
on the bushing.
7. Align the actuator assembly with the hole
in the lid and tighten the hex nut.
8. Reinstall the knob and tighten the set-
screw securely.
Star Washer
Bushing/Collar
Torsion Spring
Cam & Shaft Assembly
4-25
Knob
Setscrew
E-Ring
Hex Nut
Flat Washer