Installing The Dishwasher - KitchenAid briva KIDS01EK Technical Education

WARNING
Excessive Weight Hazard
Use two or more people to move and
install dishwasher.
Failure to do so can result in back or other
injury.
DIRECT WIRE METHOD
If the dishwasher must be directly wired to
meet local codes, the power supply cord must
be removed, and the dishwasher wired di-
rectly. Electrical connections must be con-
tained within the terminal box, and meet all
national and local codes and ordinances.
IF THE POWER SUPPLY CORD IS REMOVED,
THE DISHWASHER MUST BE CONNECTED
WITH COPPER WIRE ONLY.
Route the direct wire so that it does not touch
the lower part of the dishwasher tub.
If you are not using the "Direct Wire Method,"
proceed to "Mounting The Dishwasher" on
page 2-8.
WARNING
Electrical Shock Hazard
Disconnect electrical power at the fuse
box or circuit breaker box before install-
ing dishwasher.
Failure to do so can result in death or
electrical shock.

Installing The Dishwasher

2-6
1. Lay the dishwasher on its back.
2. Remove the two screws from each side of
the front panel, and the one screw above
the ground fault circuit interrupter (GFCI),
and remove the front panel.
Screws
Front Panel
3. Remove the terminal box screw and re-
move the terminal box.
4. Remove the power cord green ground
wire from under the green ground screw.
5. Remove the twist-on connectors and dis-
connect the black and white wires.
Power Cord
Green Ground
Wire
Screw
GFCI
Terminal
Box Screw
Terminal
Box
Do Not Remove
This Grommet
Green Ground
Screw