KitchenAid briva KIDS01EK Technical Education page 45

d) Unplug the user interface ribbon cable
from the electronic control.
Electronic Control
e) Use a 3/8" socket and remove the two
mounting nuts from the user interface
and remove the interface assembly.
Nut
User Interface
Ribbon Cable
f) Lift the touch panel with its rubber seal,
the light shield, and the contact cover
off the user interface controls.
Rubber Seal
Contact Cover
Ribbon Cable
Nut
Touch Panel
Light Shield
g) Slide the user interface board out of the
holder.
3. To remove the interlock switch:
a) Remove the front panel and ribbon
cable cover (see steps 2a and 2b).
b) Disconnect the wire connectors from
the interlock switch terminals.
c) Remove the switch screw.
Interlock Switch
Wire Connectors
4. To remove the latch assembly and wax
motor:
a) Turn off the water going to the dish-
washer.
b) Disconnect the drain line from the dish-
washer.
c) Remove the dishwasher from the
counter and place it on a protected
surface.
d) Remove the front panel and ribbon
cable cover (see steps 2a and 2b).
e) Remove the 3/8" nut from the right
mounting stud (see the photo above).
Continued on the next page.
4-9
User Interface Board
3/8" Nut
Screw