Hot Water Tank Operation - KitchenAid briva KIDS01EK Technical Education

WARNING
Water temperature over 120°F can
cause severe burns instantly or death
from scalds.
Children, disabled, and elderly are at
highest risk of being scalded.
See instructions manual before setting
temperature at water heater.
Feel water before bathing or showering.
Temperature limiting valves are
available.
The water supply MUST be turned ON before
operating the hot water tank. Operating the hot
water tank without the water supply turned on
could damage the hot water tank.
NOTE: When the hot water tank is first used, it
will take about 45 minutes for the hot water tank
to finish heating the tank water to the selected
temperature after the first dishwasher cycle is
completed. The hot water tank will then con-
tinually maintain the temperature set by the
Temp Control switch.
When the hot water tank is first heated, it is
normal for a slight amount of water to be
discharged into the dishwasher.
TEMP CONTROL SWITCH
The Temp Control switch allows the tempera-
ture setting to be changed.

Hot Water Tank Operation

3-8
To reduce the risk of scald injury, the Temp
Control switch has been factory set to "LOW"
(bottom position) which heats water to 120°F /
49°C.
If faster dishwasher cycle time is desired, the
Temp Control switch can be set to "HIGH" (top
position) which heats water to 165°F / 74°C.
The FREEZE PROTECT (center) setting will
restart the tank periodically to prevent freezing.
Use this setting if the hot water tank and dish-
washer will not be used for an extended period
of time.
GROUND FAULT
CONTROL INDICATOR (GFCI)
Test the GFCI once a month (see Steps 9
through 11 on Page 2-14).
If the GFCI will not reset and the outlet is
properly grounded and polarized, disconnect
the power supply cord, and DO NOT use the
hot water tank.
LOCKOUT CONDITION
If either light blinks, the tank is in a "lockout"
condition.
To reset, disconnect the power supply cord for
1 minute, and then reconnect the power.
If this does not correct the "lockout" condition,
DO NOT use the hot water tank.
THE HOT WATER TANK ACCESSORY IS
NOT INTENDED TO BE SERVICED. ANY
TAMPERING WITH THE ACCESSORY WILL
VOID THE WARRANTY.