Table of Contents
Advertisement
9.
Set the wash pump motor and inline heater
assembly on a work surface.
10. Remove the inline heater from the wash
pump motor hose, then remove the re-
maining hose and the moisture shield from
the inline heater.
11. Disconnect the remaining hose from the
wash pump motor.
Disconnect Inline Heater &
Washer Pump Motor Hoses
Inline Heater
Longer End Of
Moisture Shield
Heater Hose
12. Disconnect the white, white-red, and green
wire connectors from the inline heater
terminals.
White Wire
White-Red
Wire
Green Wire
REASSEMBLY NOTES:
• Make sure that you position the inline heater
• Position the curved hose so the shorter end
Wash Pump
Motor
4-17
in the assembly with the wire connectors
facing the top of the unit and the moisture
shield opening facing down, as shown. Route
the wires down so the wire post can be
inserted into the hole in the chassis.
is at the inline heater, and the longer end is
at the sump (see photo at top of left column).
Inline Heater With Wires Facing Up
Wire Post
Advertisement
Table of Contents
Troubleshooting
