Normal Cycle Operation Chart - KitchenAid briva KIDS01EK Technical Education

NORMAL CYCLE OPERATION CHART

CYCLE
NAME
(and temperature of water heating pauses / thermal holds where present)
Pre-Cycle Drain & Main Wash (145°F / 62°C) & Rinse &Purge &
Rinse & Final Rinse (145°F / 62°C) & Open Lid (Air Dry)
NORMAL
Sani Rinse Option:
• Raises Final Rinse to 160
• Adds 2:00 min. to Final Rinse between the thermal hold and rinse aid dispense interval.
"Vent" / Power Bus
Lid Actuator
Fill
OPERATION
OF LOADS Wash Motor
Dispenser
(Rinse Aid)
Drain Motor
Heater
Final Rinse
Thermal Hold
CYCLE SEQUENCE
° °
F / 71 C.
Energized to provide power bus to small loads from the beginning of the
cycle to the end of the cycle.
Energized after the final rinse thermal hold through the end of the cycle.
Engages door latch release mechanism that opens the door lid when
actuator turns off at the end of the cycle.
Energized at the beginning of the Main Wash (0:52sec.), all rinses, and the
purge (0:44 sec. each).
Energized in middle of the Main Wash and all rinses.
Energized after the final rinse thermal hold (1:00 min.).
Energized (for minimum of 10 seconds and up to 8:10 min.) to assure sink
is empty before running a cycle. Also energized at end of Main Wash, all
rinses, and the purge (0:30 sec. each).
Energized during Main Wash and all thermal holds.
Occurs after the fill and pause intervals at the beginning of the Final Rinse.
6-4
CYCLE
TIME
(without
thermal holds)
26:53 min.