Table of Contents
Advertisement
Installation
3-1
3. Installation
3.1 Set up the scan station
Your wide format scanner should be placed either on a sturdy table or
the specially designed stand-alone floor stand. The 25" models are
small enough to place on your desk.
Make sure there is enough space behind the scanner to allow the
media to run out. Thick stiff media requires space that is at least as
large as the media length.
Slots or openings in the cabinet at the back or bottom are provided for
ventilation. This ensures reliable operation of the product and protects
it from overheating. These openings must never be blocked or
covered by placing the unit on a bed, sofa, rug, or other similar soft
surface. Your scanner should never be placed near or over a radiator
or heat register. You should not place the scanner in a built-in
installation unless proper ventilation is provided.
See also the Safety Instructions at the end of this operator's guide.
3.2 Smart Card
Check that the scanner Smart Card is correctly installed (contact side
downwards) and corresponds to your scanner model. You will find the
Smart Card in the small drawer labeled "PUSH" behind the scanner
front streamer (remove the streamer to access the drawer).
The scanner will only function correctly when a Smart Card is
inserted. Notice that the SCSI DIL switch controls are in the Smart
Card drawer. Setting the DIL switch controls is described under the
sections for SCSI installation.
3.3 Install Drivers and Maintenance software
You are now ready to install the setup controls, panel commands,
basic drivers and maintenance utilities for your scanner. Insert the
WIDEsystem TOOLS CD-ROM and click the relevant installation
option(s). Installing the WIDEsystem software will also install your
drivers. Follow the installation instructions described in the
WIDEsystem TOOLS User's Guide that is included on the CD.
Advertisement
Table of Contents
