Installation; System Requirements; Installation Steps - Contex HD iFLEX User Manual

Installation

Installation

System requirements

•
PC or supported workstation. Recommended requirements: 1.6GHz Dual Core processor or better, 2 GB RAM, 5 GB of available hard drive space,
USB 2.0 interface.
•
Compatible Windows operating system – View the ws/readme.htm file on the WIDEsystem TOOLS CD-ROM.
•
The WIDEsystem TOOLS CD supplied with your scanner.
•
Scanning software or compatible third party software.
•
Grounded power outlet.
•
PC with USB port or enabled Gigabit port.

Installation Steps

To get your scanner up and running, follow the steps below in their written order.
1
Set up the scan station
Your wide format flatbed scanner should be placed on a stable, level and completely
flat (plane) surface such as a sturdy table. If convenient, you can place the backend of
the scanner against a wall. The lid will not open all the way back and stops at an
approximate 650 angle.
It is very important to follow the instructions below to ensure the scanner is setup with
optimal stability and without tension on the scanner's frame. Failure to do so can
produce poor scanning results and cause damage to the scanner device over time.
IMPORTANT: DO NOT YET CONNECT THE SCANNER TO
POWER OR PC.
See the Safety Instructions at the end of this operator's guide
5