Changing The Glass Plate - Contex Wide Format Color Operator's Manual

5-6
Figure 5-3 Slider in the exit position
5.3.2 Flip Open the Pressure Platen – ATAC models
The following applies only for scanner models with Automatic
Thickness Adjustment Control (ATAC) functionality.
1. Push down on the two lever buttons found near the insertion slot
on each side of the scanner's top cover.
2. The cover locking mechanism should now be disengaged.
3. As you hold both lever buttons down, place your free fingers in the
insertion slot and flip the cover open.
4. The pressure platen with the white metal areas is under the
scanner cover. Hold the cover open as you clean.

5.4 Changing the glass plate

Some scanner models allow users to detach the glass plate from the
scanner in order to replaced scratched glass plates with new ones.
On other scanner models, a service technician must preform this
process. See your scanner's model specifications to see the glass
plate is detachable on your scanner.
To replace detachable glass plates:
1. Remove the pressure platen as described in the section above.
2. The glass plate will be exposed and accessible.
Insertion Slot