Contex Wide Format Color Operator's Manual page 24

4-4
3. Wait LED
The Wait LED lights when the scanner power is turned on, and stays
on during the internal diagnostic and stabilization phase. Keyboard
input is prevented during this time.
The Wait indicator reveals the status of the scanner's self-adjustment
procedure, which consists of both stitching and light profile
adjustment. If the scanner does not self adjust the stitching and light
profiles may change over time due to thermal changes in the scanner.
The Wait indicator works in the following way:
•
When the Wait Indicator is off, the self-adjustment is up-to-
date, and the scanner is ready to scan.
•
When the Wait Indicator is on, the scanner is warming-up or
re-adjusting; a scan may be issued, but quality may be
compromised (when adjusting is completed, the Wait Indicator
turns off). To allow the scanner to self adjust do not (re)move
original or change Original Pressure Platen position while the
Wait Indicator is on.
•
When the Wait Indicator is flashing (and the Diagnostics
Indicator is off) re-adjusting is needed, but not possible; any
original in the scanner should be removed, and Original
Pressure Platen should be returned to the normal position
(also in this situation a scan may be issued, but the quality will
be compromised). When adjusting is again possible, the Wait
Indicator stops flashing, but continues to be on until the self-
adjust is complete.
•
The Wait Indicator is on during basic calibration to indicate
that the original should not be (re)moved during this
procedure (for the same reason the scanner keyboard is
disabled during basic calibration).
Operator Panel and Indicators