Installation; Installation Steps - Contex GX67D Operator's Manual

Installation

3. Installation

3.1 Installation Steps

On All Scanners
To get your scanner up and running, follow the steps below in their written order. You will find
detailed descriptions of each step in the sections specified under the column "Instructions in
section...".
Step number Description
1 Insert WIDEsystem TOOLS CD-ROM into your PC.
POWER OR PC.
You will install WIDEsystem before you connect the scanner or install any
scanner software applications. Your scanner drivers are automatically
installed with WIDEsystem and your PC will then be fully prepared to
detect and setup the newly connected scanner device.
Start up the WIDEsystem TOOLS CD-ROM by inserting the CD-ROM into
your PC. Normally the setup program interface will start automatically. If it
does not, see section 3.2 for instructions on manual startup.
2 Install WIDEsystem software
Click on the option Install WIDEsystem Software from CD main menu or
run the setup.exe program directly from the WIDEsystem (ws) folder on the
CD-ROM. Follow the installation instructions that appear on your screen.
3 Install Scanner Maintenance Software
Click on the option Install Scanner Maintenance Software from CD's
menu. Follow the instructions that appear on your screen.
4 Shut down (power off) the PC
Your PC is now prepared and must be powered off before connection with
the scanner.
5 Perform Preliminary Maintenance – Cleaning
Clean your scanner's flat surface so dirt and dust are not dragged into the
scan area with the original. Clean the internal Scan area.
6 Set up your scan station and control the smart card
Your wide format copy scanner should be placed either on the specially
designed stand-alone floor stand or on a sturdy table. For sheet feed
models, make sure there is enough space behind the scanner to allow the
media to run out. Make sure that the scanner's smart card is in place.
7 Connect interface cable to scanner and PC
8 Connect scanner power cable
The scanner is equipped with a three-wire (pin) grounding type plug. If
you cannot insert the plug into your outlet, contact your electrician to
replace the outlet and ensure a grounded power connection. Do not try to
defeat or ignore the purpose of the grounding-type plug.
IMPORTANT : DO NOT YET CONNECT THE SCANNER TO
3-1
Instructions in
section...
3.2
3.2
3.2
3.10, 7.2
3.3, 3.4
3.5, 3.6, 3.7, 3.8