Table of Contents
Advertisement
Installation
3-15
3.8 Installation Verification
Turn on the power to the computer and the scanner.
If you have not yet done so, install the Scanner Maintenance Software
and your scanning applications on your PC. Follow the installation
instructions supplied with each item. The Scanner Maintenance
Software is on your WIDEsystem TOOLS CD.
Start up the maintenance software (Start – Programs – Scanner
Maintenance). The program will detect your scanner if it is installed
correctly and display an introduction to the maintenance wizard.
Otherwise, a message will inform you that your scanner could not be
detected. If this is the case turn off power to all connected devices
and reboot the system.
3.9 Preliminary Maintenance
Once you have setup your scanner and verified your installation, it is
important that you run your first maintenance session before working
with the scanner.
Shipping and transportation of your scanner from the factory may
have affected the camera positions and it may be necessary to align
the cameras and then calibrate.
Follow the instructions described under the chapter on Maintenance in
this Operators Guide and in the Scanner Maintenance instructions
found on the WIDEsystem TOOLS CD-ROM that came with your
scanner.
Advertisement
Table of Contents
