Contex Wide Format Color Operator's Manual page 13

Installation
3.6.2 Connect the scanner with the USB cable
1. Locate the USB cable that came with your scanner.
2. Connect the PC end to a USB port on your computer
3. Connect the peripheral end to the USB connection socket on your
scanner.
4. If you have not yet installed the driver through the WIDEsystem
TOOLS CD-ROM, Windows will display the "New Hardware
Found Wizard dialog box after you connect the cable.
5. If an "Unknown device is found" message appears after you plug
in the USB cable, follow the steps described below under
Unknown device is found message.
6. The driver is located on the WIDEsystem TOOLS CD-ROM that
came with your scanner. Insert the CD into your CD drive.
7. Follow the installation instructions in the WIDEsystem TOOLS
User's Guide that came with the CD. The scanner drivers are
installed through an installation wizard.
3.6.3 "Unknown device is found" message
If your system has problems detecting the scanner, make sure your
USB port is enabled (see above). If your system still does not detect
the device, disconnect the USB cable, unplug the power to your
scanner and turn off the computer. Then reconnect the scanner and
restart the PC and restart the driver installation.
3-8