Installation - Contex FSS4300 Operator's Manual

Installation

5-1
5. Installation
The Full Scale Color Scanner should be placed on a table in such a
way that the front of the machine overhangs the table's edge by
approximately 1 cm. This ensures that the scanned original can hang
freely from the exit slot at the front of the machine. The table should be
placed a few centimeters from the wall, to allow large sized originals to
hang down freely behind the table. You can also place the FSS
scanner on the specially designed stand-alone floor stand which can
be purchased separately.
Important: Before connecting the power cord to an electrical outlet,
ensure that the voltage selector switch (just above the mains inlet) is
set to the correct voltage.
Make sure that power is turned off, and connect the SCSI cable that
came with your interface kit to one of the two SCSI connectors found
at the back of the Full Scale Color Scanner.
If the scanner is the last device on the SCSI bus, turn on the built-in
active SCSI terminator (see Scanner SCSI DIL-switch setup),
otherwise make sure it is turned off.
You must install the SCSI interface board on your PC. The SCSI
interface board is part of your interface kit that came with your
scanner. Read carefully the following sections and the documentation
that came with interface kit. If your PC already has a built in ASPI
compatible SCSI board you might be able to use that instead. For best
performance, we strongly recommend that you use the board
delivered with the Full Scale Color Scanner.
For UNIX workstations with a built-in SCSI interface, simply turn power
off and connect the scanner SCSI cable.
Set up the SCSI address of your scanner. See instructions on SCSI
DIL-switch setup at the end of this chapter.
Install the WIDEimage scanner software. Installation instructions are
described in the WIDEimage User Manual.