Installation; System Requirements; Installation Step By Step - Contex XD2490 User Manual

Installation

Installation
Follow the steps below for quick and easy installation of your scanner and scanner drivers.

System requirements

•
PC or supported workstation. Recommended requirements: Core 2 processor, 2 GB RAM, 5 GB of available hard drive space, USB 2.0 interface.
•
Compatible Windows operating system – View the ws/readme.htm file on the WIDEsystem TOOLS CD-ROM.
•
Enabled USB port on your PC.
•
The WIDEsystem TOOLS CD supplied with your scanner.
•
Scanning software and/or compatible third party software.
•
Grounded power outlet.

Installation step by step

1
Set up the scan station
Your scanner should be placed either on the specially designed stand-alone floor stand
or on a sturdy table. Make sure there is enough space behind the scanner to allow the
media to run out.
2
Install drivers and tools on your PC
IMPORTANT: You must install your scanner's drivers and tools before you
connect the scanner or install any scanner software applications.
1. Insert the WIDEsystem TOOLS CD-ROM into your PC. Normally the setup
program interface will start automatically. If it does not, locate the setup.exe file on
the CD and start it manually.
2. Install WIDEsystem. Follow the installation guide on your screen. You will be
asked to select your language and other important system preferences.
3. Install Scanner Maintenance. Follow the installation guide on your screen. You will
be asked to select your language.
4. Remove the CD-ROM when installation is complete.
See the section on Software Applications for Scanning »
IMPORTANT: DO NOT YET CONNECT THE SCANNER TO
POWER OR PC.
See also the Safety Instructions at the end of this operator's
guide
6