Information Messages; Needle Not In Basic Position; Threading Mode; Thread Breakage - DURKOPP ADLER 580 Operating Instructions Manual

11.

Information messages

11.1

Needle not in basic position

11.2

Threading mode

11.3

Thread breakage

11.4

Pressure monitor

11.5

Invalid cutting configuration

If the needle is not in its basic upper position at the sewing start, this
information code will appear.
Error Correction
–
Turn the handwheel until the information disappears.
As long as the sewing automat is in the "Threading mode", the
information code in the margin appears.
Error Correction
–
Press the button at the head cover.
Should the thread breaks during the sewing operation, the information
code in the margin appears in the display.
Correction
–
Press the button at the head cover to get into the "threading mode".
–
Thread in the sewing automat.
–
Press the button at the head cover again to exit the "threading
mode".
The pressure monitor monitors the air pressure of the air supply. When
there is no compressed air or the pressure is too little this information
code will appear on the display.
Error correction
–
Switch off the sewing automat.
–
Supply sufficient compressed air.
–
Switch the sewing automat on again.
Hint
Appears only with the "Multiflex" setting
In case an invalid cutting configuration is chosen, the opposite hint
appears.
Error correction
–
Check and set the control unit and the data of the knives and
cutting blocks in use.
–
Check that suitable knives and cutting blocks are being used and
redo the setting.
1
47