Programming A Sequence - DURKOPP ADLER 580 Operating Instructions Manual

10.6.3 Programming of a sequence
42
"S"-key Press the "S"-key to switch from the main level to the
menu for programming a buttonhole sequence.
Selection of the sequence number
keys ñò
Select the menu item "sequence number" with
the ñò keys.
"OK"-key Press the "OK"-key to activate the menu item.
keys ñò
Select the sequence number that is to be programmed
with the ñò keys.
"OK"-key Press the "OK"-key to activate the menu item.
Programming a buttonhole sequence
7
6
Keys ñò Select the field 1 with the ñò keys.
"OK"-key Press the "OK"-key.
The first column indicates the buttonhole's place within the sequence.
In the second column the desired buttonhole can be programmed for
the selected place. As an aid for programming you find indicated in
field 7 the shape and in field 4 the most important parameters. (5 =
cutting length, 2 = stitch length, 6 = throw width, 3 = cutting mode)
If the respective buttonhole is to be sewn several times successively
you can set the desired number of repetitions in the third column.
Keys ñò
Select the desired buttonhole sequence with
the ñò keys.
"OK"-key Press the "OK"-key.
The buttonhole program will be selected.
Keys ñò
Select the desired number of repetitions with
the ñò keys.
"OK"-key Press the "OK"-key.
The desired number will be selected.
Should it be necessary to insert more buttonhole programs, please
begin from the 1st step on. It is not possible to resume the sewing
process using the foot switch (pedal)! Resuming the sewing process is
only possible using the "OK"-key on the control panel or use the
manual switch.
5 4 3 2
1