Information Messages; Needle Not In Basic Position; Pressure Monitor; Thread Breakage - DURKOPP ADLER 559 Instruction Manual

1
4
11.

Information messages

11.1

Needle not in basic position

11.2

Pressure monitor

11.3

Thread breakage

30
Replacing the knife
–
Loosen screw 1 and remove the fabric holder 4.
–
Take out the old knife 2.
–
Stick the new knife 3 in the groove and snap it off in the arrow
direction.
–
Tighten the screw 1.
–
Fix the fabric holder using the screw 4.
Hint!
The knife may not exceed
the fabric holder.
2
If the needle is not in its basic position at the sewing start, the
information code in the margin appears.
Correction
Turn the handwheel until the info disappears. (See chapter 8.3)
The pressure monitor supervises the pressure of the air inlet. If no
compressed air is available or the pressure is too low, the information
code in the margin appears in the display.
Correction
–
Switch the sewing automat off.
–
Provide sufficient compressed air.
–
Switch the sewing automat on.
Should the thread breaks during the sewing operation, the information
code in the margin appears in the display.
Correction
–
Press the button at the head cover to get into the "threading mode".
–
Thread in the thread new.
1
3