Removing And Inserting The Clamping Plates - DURKOPP ADLER 580 Operating Instructions Manual

3.2

Removing and inserting the clamping plates

1
Caution: Danger of injury !
The removing and inserting of the clamping plates 1 has to be done
with the sewing automat switched off or in the position "Threading
mode" (see chapter "Threading mode").
Removing the clamping plate
–
Lift the right clamping plate 1 slightly at the rear and pull it to the
back. Then remove the clamping plate to the right side.
–
Lift the left clamping plate 1 slightly at the rear and pull it to the
back. Then remove the clamping plate to the left side.
Inserting the clamping plates
–
Push the clamping plate into its front seat.
–
Then snap it at the rear into the pin 3.
Important note!
Wrongly inserted clamping plates can lead to damage or injuries
3
1
13