Configuring Telephone Connections - Gigaset S540 IP User Manual

To establish a connection, the public IP
address or the DNS name of the router
and, where applicable, the port number
on the router, must be indicated in the
Web browser of the remote PC.
Configuring telephone
connections
You can configure up to five phone num-
bers on your phone: your fixed network
number and four VoIP phone numbers.
You need to set up a VoIP account with
your VoIP provider for each VoIP phone
number. You must save the access data for
each account in the phone. You can assign
a name to each connection (VoIP and fixed
network).
To configure the connections:
¤
Open the following Web page:
¢
Settings Telephony
A list (see Figure 2) will be shown with all
possible connections that you can config-
ure, or have already configured, for your
phone.
Figure 2 List of possible connections
The list will show the following:
Name
Name of the connection. This will show
the name that you have defined for the
connection (page 80, page 87) or the
default name (IP1
nections, Fixed Line
connections).
¢
Connections.
to IP4 for VoIP con-
for fixed network
Status
The status of the connection will be
shown for VoIP connections:
registered
The connection is activated. The phone
has been successfully registered. You
can use the connection to make calls.
Disabled
The connection is deactivated. The
phone is not registering with the corre-
sponding account with the VoIP serv-
ice. You can not use the connection to
make or receive calls.
Registration failed
(Examples)
The phone could not be registered with
the VoIP service, e.g. because the VoIP
access data is incomplete or incorrect,
or because the phone is not connected
to the Internet. There is information
about this in the section entitled "Ques-
tions and answers" from page 94.
Active
You can use the option in the
umn to activate (½) and deactivate (Õ)
VoIP connections. If a connection is
deactivated, the phone will not register
for this connection. The connection can
be activated/deactivated by clicking
directly on the option. The change does
not need to be saved.
To configure a connection or to change
the configuration of a connection:
¤
Click on the button behind the con-
Edit
nection.
This will open a Web page where you can
make the settings needed. Read on:
u
in the section "Configuring the VoIP
connection" on page 80 or
u
in the section "Configuring the fixed
network connection" on page 87
Web configurator
/
Server not accessible
Active col-
79