Table of Contents
Advertisement
If the MSN you have deleted was the send
connection
(page 112)
then a new send connection (the MSN with
the lowest ranked number) will automati-
cally be assigned to this internal party.
Configuring VoIP
connections
You can configure up to six VoIP connections
on your telephone, i.e., you can assign up to
six VoIP phone numbers to your phone.
You need to set up an IP account (VoIP
account) with a VoIP provider for each con-
nection. You must save the access data for
this IP account on your phone. The IP wizard
will help you to do this.
Starting the IP wizard:
If your base is connected to the Internet and
ISDN, start the IP wizard as follows:
¢
¢
v
ÏSettings
¢
VoIP
If your base is connected to the Internet and
analogue fixed line, start the IP wizard as fol-
lows:
¢
¢
v
ÏSettings
In both cases you will see the following
question in the display:
IP Wizard
?
Start IP
installation wizard?
No
The remaining procedure for the IP wizard is
described on
page
24.
Each time you run the IP wizard you can
configure/reconfigure one VoIP connection
(IP account).
of an internal party
Connection Wizard
VoIP Wizard
Yes
Configuring the system settings
¤
Restart the IP wizard if you wish to config-
ure/reconfigure another VoIP connec-
tion.
Automatic update for the VoIP
provider settings
After the first download of the VoIP provider
settings, your phone will check daily
whether a newer version of the file for your
VoIP provider is available from the Internet
on the configuration server. If there is an
update available, the message New profile
available. Update? is displayed in the idle
display of the base.
§Yes§
Press the display key to confirm
the prompt.
~
Enter the system PIN if neces-
sary and press
The new data for your VoIP provider will be
downloaded and saved on the phone.
If you answer the prompt with
phone returns to idle status. Your telephone
will not remind you of this new profile again.
The message will only be shown again if a
newer version of the provider data is availa-
ble.
A profile update will only be started if no
other profile or firmware update is taking
place at the time.
§OK§
.
§No§
, the
135
Advertisement
Table of Contents
