Storing A Child Seat - Acura 1995 NSX Online Reference Owner's Manual

Main Menu
Child Safety
2. Using the dimensions shown,
measure and mark the location of
the attachment point on the
interior panel.
3. Use a razor blade or sharp knife to
carefully cut a 2.5 cm (1 in)
diameter circle at the point you
marked. Cut through one layer at
a time. You will need to remove
two layers to reach the tether
attachment.
4. Install the tether hardware that
came with the child seat.
Tighten to:
22 N.m (2.2 kg-m, 16 1b-ft)
Make sure to route the tether
through the space between the head
restraint and seat.
If you are not sure how to install the
bracket, have it installed by your
Acura dealer.
Driver and Passenger Safety
Table of Contents
If you need an anchor plate and
mounting hardware, you can obtain
them by writing to:
Acura Automobile Division
Customer Relations Office
American Honda Motor Co., Inc.
1919 Torrance Blvd.
Torrance, CA 90501-2746
Canadian Cars
The anchor plate and mounting
hardware for a top tether are sup-
plied with the car. When installing,
make sure the toothed washer is on
the bottom of the bolt.
TOOTHED WASHER
The supplied anchor plate is de-
signed only for mounting a child
restraint. Do not use it for any other
purpose.

Storing a Child Seat

When you are not using a child
restraint, either remove it or make
sure it is properly secured so it
cannot be thrown around the car
during a crash.