Using Child Restraints With Tethers - Acura 1995 NSX Online Reference Owner's Manual

Main Menu
1. Place the child restraint in the
passenger's seating position.
Route the lap/shoulder belt
through the seat according to the
seat manufacturer's instructions.
2. Insert the latch plate into the
buckle. Make sure it is fully
latched.
3. Slowly pull the shoulder portion of
the belt out of the retractor until it
stops.
4. Allow the belt to slowly feed back
into the retractor. You should hear
a clicking noise that indicates the
locking mechanism has engaged.
5. After the belt has retracted fully,
pull up on the shoulder portion to
remove any slack.
Table of Contents
6. Push and pull on the child seat to
verify that it is held firmly in place.
If not, unlatch the seat belt, allow it
to retract fully, and repeat these
steps.
To unlatch the seat belt, push the red
PRESS button on the buckle.
Guide the belt across to the door
pillar. If the belt doesn't retract
easily, pull it out and check for twists
or kinks.
Child Safety
Using Child Restraints w i t h
Tethers
Your NSX is equipped with an attach-
ment point for a child restraint
system that uses a top tether. The
tether attachment point is located on
the panel behind the passenger's
seat-back.
1. Adjust the passenger's seat fully
forward to make room behind the
seat-back.
Driver and Passenger Safety
CONTINUED