Table of Contents
Advertisement
Main Menu
Spark Plugs
IGNITION COIL
10 mm BOLT
2. Disconnect the three ignition coils
from the wire harness by squeez-
ing the harness end of each
connector and pulling.
3. Remove the two 10 mm bolts
holding the ignition coil. Remove
the ignition coil by pulling it
straight out as you twist it slightly.
Maintenance
Table of Contents
SPARK PLUG SOCKET
4. Use a 16 mm (5/8 in.) spark plug
socket, with a 6 in. extension, to
remove the spark plug.
5. Put the new spark plug into the
socket, then thread it into the hole.
Screw it in by hand so you do not
crossthread it.
Advertisement
Chapters
Table of Contents
