Acura 1995 NSX Online Reference Owner's Manual page 148

Main Menu
OIL FILTER
3. Remove the oil filter and let the
remaining oil drain. A special
wrench (available from your Acura
dealer) is required to remove the
filter.
4. Install a new oil filter according to
instructions that come with it.
Table of Contents
5. Put a new washer on the drain
bolt, then reinstall the drain bolt.
Tighten it to:
46 N . m (4.6 Kg-m, 33 Ib-ft)
6. Refill the engine with the recom-
mended oil.
Engine oil change capacity
(including filter):
5.0 (5.3 US qt, 4.4 Imp qt)
7. Replace the engine oil fill cap.
Start the engine. The oil pressure
indicator should go out within five
seconds and the gauge should
register normal oil pressure. If it
does not, turn off the engine and
reinspect your work.
8. Let the engine run for several
minutes and check the drain bolt
and oil filter for leaks.
Engine Oil
9. Turn off the engine, let it sit for
several minutes, then check the oil
level. If necessary, add oil to bring
the level to the upper mark on the
dipstick.
NOTICE
If you change your own oil, please
dispose of the used oil properly. Put it
in a sealed container and take it to a
recycling center. Do not discard it in a
trash bin or dump it on the ground.
The oil and filter should be changed
every 6 months or 12,000 km (7,500
miles), whichever comes first. Under
severe driving conditions, they
should be changed every 3 months
or 6,000 km (3,750 miles). See page
139 for a description of severe driving
conditions.
Maintenance