Table of Contents
Advertisement
Main Menu
Lights
BULB
COVER
CONNECTOR
3. Remove the cover from the back
of the burned-out bulb by turning
it counterclockwise.
Maintenance
Table of Contents
4. Remove the electrical connector
from the bulb by grasping it
between your thumb and fingers
and pushing downward while you
wiggle it slightly. Make sure you
pull on the connector, not the
wires.
5. Unclip the end of the hold-down
wire from its slot. Pivot the wire
up out of the way and remove the
bulb.
6. Insert the new bulb into the hole,
making sure all the tabs are in
place. Pivot the hold-down wire
over the end of the bulb and clip
the end back into the slot.
7. Push the electrical connector
back onto the bulb. Make sure it
is on all the way.
8. Replace the bulb cover. Line up
the three tabs, push the cover in,
and turn it clockwise until it
locks.
9. Reinstall the headlight motor
fuse.
10. Turn on the head lights to test
the new bulb.
Advertisement
Chapters
Table of Contents
