Datamax M-Class Mark II Maintenance Manual page 89

3. Slide the Supply Hub and Plastic Spacer out of the Assembly Casting.
Supply
Hub
Installation:
1. Slide the Supply Hub Shaft through the Plastic Spacer and partially into the Assembly
Casting.
2. After ensuring that the Pin on the Supply Hub Shaft engages the Notch in the Assembly
Casting, slide the Supply Hub Shaft completely through then install the Washer and
secure the components to the Assembly Casting with the Screw.
3. Install the Thermal Transfer Assembly; see Section 4.9.
Removal and Replacement
Supply
Hub Shaft
Pin
Supply
4-25
Assembly
Casting
Plastic
Spacer
Notch
Hub
Shaft
Screw
Washer