Datamax M-Class Mark II Maintenance Manual page 57

Displayed Message
GAP MODE
FAULTY SENSOR
HEAD CLEANING FAULT
OUT OF STOCK
Troubleshooting
Fault Messages (continued)
Description
Consistently high
sensor readings have
occurred.
The scheduled
maintenance interval
has been exceeded
three times.
Media cannot be
detected.
3-15
Possible Solution(s)
Press any key to continue then try
the following:
1) Retry calibration, ensuring that
media was removed from the
sensor during the appropriate
calibration steps.
2) Clean the sensor (see Section
2.1.2) then retry calibration.
3) The sensor may be defective; see
Section 4.6.
4) The Main Logic PCB may be
defective; see Section 4.4.
Clean the printhead (see Section
2.1.1).
Try the following:
1) Ensure that media is properly
loaded; and, if using die-cut
media with a transparent liner or
large notches, ensure the PAPER
EMPTY DISTANCE has been
adjusted.
2) Adjust the Media Sensor position.
3) Perform calibration; see Section
2.2.2.
4) The Media Sensor may be
defective or the cable loose; see
Section 4.6.
5) The Main Logic PCB may be
defective; see Section 4.4.