Datamax M-Class Mark II Maintenance Manual page 82

Screw
4. Disconnect the Drive Motor Cable from the Power Supply PCB.
5. Remove the two Screws and Lock Washers that secure the Drive Motor then carefully
remove the Drive Motor.
Installation:
1. Carefully insert the motor's gear into the drive gear train, rotating the Drive Motor so
that it rests flush against the Isolator, with gears meshed, aligned to the screw holes.
Removal and Replacement
Printhead
Assembly
Inner
Bearing Plate
Drive
Motor Cable
4-18
Platen
Block
Assist
Roller
Isolator
Drive
Motor
Lock
Washers
Screws