Table of Contents
Advertisement
12-10 SETUP Screen
Item
H PHASE
For adjusting the horizontal phase of the unit in relation to the signal
(external sync signal) input through the SYNC IN connector on the left
side of the unit.
Delaying the horizontal phase of the unit in relation to the external sync
signal .
................... Increase the number
Speeding up the horizontal phase of the unit in relation to the external
sync signal .
................... Decrease the number
* Adjustment is not possible if the external sync signal is not input. Possible
values are indicated by ***.
SC PHASE
For adjusting the sub-carrier (SC) of the unit in relation to the signal
(external sync signal) input through the SYNC IN connector on the left
side of the unit.
Rotating the sub-carrier clockwise in relation to the external sync signal
................... Increase the number
Rotating the sub-carrier anticlockwise in relation to the external sync signal
................... Decrease the number
* Adjustment is not possible if the external sync signal is not input. Possible
values are indicated by ***.
The phase will change when the power is turned on/off. The SC phase
must be adjusted each time the power is turned on.
CAM MIC +48V
To set whether or not 48V voltage should be applied to the MIC IN connector
on the front section.
ON ............. 48V applied.
OFF ............ 48V not applied.
PAGE BACK
The CAMERA MENU returns when the SHUTTER dial is pressed with
the cursor at this position.
Function, Operation
12. SETUP MENU
Variation Range Initial Setting
0
128
to
256
0
to
128
256
ON
ON
OFF
–
–
77
- Quick Links:
- Camera Settings
- Specifications
Hide quick links:
Advertisement
Table of Contents
