Connecting A Pc - JVC GY-DV500U Instructions Manual

11-2 Connecting a PC

PUSH
Y/C OUT MONITOR OUT LINE OUT
DV connector
CH-1
MONITOR
OUT
connector
Connections
Connect the GY-DV500's VTR REMOTE connector to the RS-232C connector on the PC or the non-linear editing controller using
the TTL RS-232C converter cable.
Or connect the GY-DV500's DV connector and the DV connector of the non-linear editing controller using a DV cable.
For compatible non-linear editing controller, consult with your JVC dealer.
Settings
• To remote control the PC or non-linear editing controller by means of RS-232C, set the VCR Setup Menu item No. 050 REMOTE
SELECT to "RS232C". See page 68.
• To remote control the GY-DV500's VCR using the DV connector's IEEE1394 option, set the VCR Setup Menu item No. 050
REMOTE SELECT to "IEEE1394".
Note:
• When a cable is connected to the VTR REMOTE connector, the VTR Setup Menu is not displayed in the viewfinder. Make
settings on the VTR Setup Menu while the cable is not connected.
• When a cable is connected to the VTR REMOTE connector, the VCR operation mode will not be displayed correctly on the
Status1 screen in the viewfinder.
The S.S.F. data stored in the unit's memory can be output from the VTR REMOTE connector.
DV CAMCORDER
GY-DV500
SYNC IN TEST OUT
CH-2
VTR
REMOTE
MIC IN
LENS
VTR
REMOTE connector
AUDIO OUT
See page 68.
11. USING EXTERNAL COMPONENTS
RS-232C
TTL RS-232C
converter cable
RS-232C
(Optional VC-P893)
AUDIO IN
VIDEO IN
DV connector
PC
Non-linear editing controller
65