Switch Settings Of The Vcr Section - JVC GY-DV500U Instructions Manual

6. SETTING AND ADJUSTMENTS BEFORE SHOOTING

6-6 Switch Settings of the VCR Section

Audio input signal selection
Use the AUDIO INPUT switch to select whether the sound
recorded on audio channel 1 or 2 is the sound from the
microphone connector on the front section or the sound from
the AUDIO INPUT connector on the rear section.
See page 47.
Audio recording level adjustment selection
Select "AUTO" or "MANUAL" for the recording level
adjustment mode for each audio channel.
See page 48.
VCR Setup Menu setting
REMOTE SELECT
Confirm that "LOCAL" is selected if you want to operate on
the GY-DV500 only.
BACK TALLY MODE
Select the lightning pattern of the BACK TALLY lamp.
INPUT SELECT
Select the input video signal. To record the GY-DV500's
camera image, set to "CAMERA".
LOW CUT IN
For each audio input connector, select whether or not the
lower frequency components of the audio signal are cut.
Set to this position to eliminate the wind noise of the
microphone.
SAMPLING RATE
Select the sampling rate for audio recording (48 kHz or 32
kHz).
FRONT VOLUME ENABLE
Set whether or not the front section's audio volume control
should be used. The front section's audio volume control only
affects the CH1 audio channel.
LONG PAUSE TIME
Select the time (in minutes) until the GY-DV500 enters the
tape protection mode (drum rotation stops) when the record-
pause mode is continued for long time.
SSF MODE
Select the mode of the S.S.F. (Super Scene Finder) function.
S.S.F. function: Stores the time code of desired scenes or
cue points in the unit's memory.
See "S.S.F. function" on page 60.
DISPLAY SELECT
Select the counter display (time code or date/time indication)
when the COUNTER switch is set to "TC" or "UB".
46
OPERATE/WARNING
LIGHT
RESET ON
OFF
MONITOR
SELECT COUNTER
FILTER
CTL
1 3200k ALARM
TC
2 5600k UB
3 5600k+ND
SHUTTER STATUS
MONITOR
MENU
AUDIO
CH-1 CH-2
LEVEL
AUTO IRIS FULL AUTO BLACK LOLUX
BACK L STRETCH
NORMAL NORMAL
SPOT L COMPRESS
POWER
NG
ON OFF
PRESET/REGEN switch
CH-1 CH-2
AUDIO
LEVEL CH-1
AUDIO SELECT
CH-1
LITHIUM BATT.
Setting the time code recording function
The GY-DV500 records SMPTE-standard time code during
recording. Set the switches according to applications.
To record a time code as set in the built-in time code
generator:
• Set the PRESET/REGEN switch to PRESET.
• Set the REC/FREE switch.
If it is required to record continual time codes across different
scenes, set the switch to REC.
• VCR Setup Menu setting
Select the time code generator's framing mode as drop
frame or non-drop using the VCR Setup Menu item No. 416
"NON DROP/DROP".
To record a time code in continuation of the existing time
code on the tape:
• Set the PRESET/REGEN switch to REGEN.
For details on the time code operations including time code
presetting, see "TIME CODE OPERATION" on page 56.
REC/FREE
switch
TC GENERATOR
CH-2
PRESET FREE
AUTO
REGEN REC
MANUAL
AUDIO INPUT
CH-2 CONTINUE MENU
FRONT
REAR
GROUP ITEM SELECT DATA SET
HOLD SHIFT ADVANCE PRESET