Reproducing Time Codes - JVC GY-DV500U Instructions Manual

9-4 Reproducing Time Codes

The GY-DV500 incorporates a time code reader. During playback, the time code or user's bit data recorded on the tape is displayed
on the counter display.
FILTER
1 3200k
2 5600k
3 5600k+ND
SHUTTER STATUS
MENU
AUTO IRIS FULL AUTO BLACK
BACK L
NORMAL
SPOT L
NG
ON
OPERATE/WARNING
LIGHT
RESET ON
OFF
MONITOR
SELECT COUNTER
CTL
ALARM
TC
UB
MONITOR
CH-1 AUDIO CH-2
LEVEL
LOLUX
STRETCH
NORMAL
COMPRESS
POWER
OFF
PB
H M S F
9. TIME CODE OPERATION
Set the VCR Setup Menu item No. 516 DISPLAY SELECT to
"TC".
See page 69.
Set the counter display to indicate time code or user's bit
data.
Reproducing time codes
Press the PLAY button.
• The "PB" indicator lights up on the display and the time
code or userís bit data are indicated.
• When passing sections where the time code does not
continue during playback, the time code stops running.
The playback mode continues.
Note:
Time code more than two hours can not be displayed
correctly by consumer DV equipment, which has no
capability to display more than two hours.
59