Viewfinder Adjustment; External Monitor Adjustment - JVC GY-DV500U Instructions Manual

6-2 Viewfinder Adjustment

1.
Eyepiece
2.
Eyepiece
focusing ring
1.
3.
CONT

6-3 External Monitor Adjustment

PUSH
Colour video monitor
1.
3.~8.
SPOT L
SMTPE type color bars
White Yellow Cyan Green Magenta
1 2 3 4
Blue Black Magenta Black
8 9 0 A
Black White Black
E F G
6. SETTING AND ADJUSTMENTS BEFORE SHOOTING
1.
3.
BRIGHT
DV CAMCORDER
GY-DV500
Y/C OUT MONITOR OUT LINE OUT
SYNC IN TEST OUTPUT
CH-1 CH-2
VTR
REMOTE
2.
COMPRESS
POWER
NG
ON OFF
Red Blue
5 6 7
Cyan Black White
D
B C
H I J K
1.
Adjust the position and angle of the viewfinder.
2.
Diopter adjustment
Rotate the eyepiece focusing ring until the viewfinder screen
image is clearly visible.
3.
Brightness and contrast adjustment
When the ambient brightness changes, etc., the brightness
and contrast of the viewfinder screen can be adjusted with
the BRIGHT and CONT controls.
Display the camera built-in color bar signal on the video monitor
and adjust the colors, contrast and brightness.
1.
Connect a color video monitor to the MONITOR OUT
connector of the GY-DV500.
2.
Set the OUTPUT switch to BARS to output the color bar
signal (SMTPE type color bars).
3.
Set the monitor's BLUE CHECK function to ON so that the
screen turns entirely blue.
4.
Adjust the CHROMA control of the monitor so that there is
MIC IN
LENS
no difference in brightness between the color bars 1 and
8, 7 and D.
5.
With the BLUE CHECK function ON, adjust the PHASE
control of the monitor so that there is no difference in
brightness between the color bars 3 and 0, 5 and B.
6.
If the phase control adjustment above causes a difference
in brightness between the color bars 1 and 8, 7 and D,
start again from the CHROMA control adjustment in step 4 .
7.
Set the monitor's BLUE CHECK function to OFF to switch
the monitor back to the standard screen (R, G and B will all
appear).
8.
Use the monitor's brightness control to adjust so that the
color bars H and I disappear but J is visible.
43