Writing S.s.f. Data To Tape; Outputting S.s.f. Data - JVC GY-DV500U Instructions Manual

10-5 Writing S.S.F. Data to Tape

LOG
2.
LOG button
FILTER
1 3200k
2 5600k
3 5600k+ND
SHUTTER STATUS
MENU
AUTO IRIS FULL AUTO BLACK
BACK L STRETCH
NORMAL NORMAL
SPOT L COMPRESS
NG POWER
ON
CH-1
LITHIUM BATT.

10-6 Outputting S.S.F. Data

10. S.S.F. (Super Scene Finder) FUNCTION
REW STOP FF PLAY STILL
1.
STOP button
2.
REW button
OPERATE/WARNING
LIGHT
RESET ON
OFF
MONITOR
COUNTER
SELECT
CTL
ALARM
TC
UB
MONITOR
CH-1 AUDIO CH-2
LEVEL
LOLUX
OFF
AUDIO CH-2
TC GENERATOR
LEVEL CH-1 CH-2
PRESET FREE
AUTO
REGEN REC
MANUAL
AUDIO SELECT
AUDIO INPUT
CH-1 CH-2 CONTINUE MENU
FRONT
REAR
GROUP ITEM SELECT DATA SET
HOLD SHIFT ADVANCE PRESET
CONTINUE button
PUSH
DV CAMCORDER
GY-DV500
Y/C OUT MONITOR OUT LINE OUT
CH-1 CH-2
VTR
REMOTE
VTR REMOTE connector
S.S.F. data stored in the unitís memory can be written to the
beginning of tape.
Precautions when writing S.S.F. data
When S.S.F. data stored in the memory of the GY-DV500 is
written to the beginning of the rewound tape, approximately 5
seconds of recorded video and/or sound will be erased at the
beginning.
In the case of important recordings, leave 5 seconds or more
of the tape unrecorded before starting recording.
Operation
1.
Press the STOP button to enter the stop mode.
2.
Press the REW button while the LOG button is kept pressed.
• The REW indicator blinks during tape transport in the
writing position.
The LOG indicator lights while S.S.F. data are being
written to the tape.
• When writing to the tape is completed, the LOG indicator
goes out.
About the Scene End Cue Up Function
When the CONTINUE button is pressed while the LOG
button is kept pressed in the stop mode, the tape winds
to the S.S.F. data's last OUT point, after which the unit
enters the record-pause mode. (Scene End Cue Up)
The FF button's LED blinks during the Scene End Cue
Up mode.
Note:
Once a tape with recorded S.S.F. data is ejected and then
reinserted again, the previous data will be erased if new
S.S.F. data are recorded on the tape.
The S.S.F. data stored in the unit's memory can be output by
RS-232C control via the VTR REMOTE connector.
SYNC IN TEST OUT
MIC IN
LENS
F o r h o w t o c o n n e c t , s e e
"Connecting a PC" on page 65.
63