Using External Components; Connecting A Video Component With Dv Connector - JVC GY-DV500U Instructions Manual

11. USING EXTERNAL COMPONENTS

11-1 Connecting a Video Component with DV Connector

Rear section of GY-DV500
CH-1 AUDIO IN CH-2
DV
EARPHONE LINE MIC LINE
+48V
ON
DC INPUT
DC OUTPUT
DV connector
When connecting the GY-DV500 to a non-linear editing controller or other component with DV connector, be sure to observe the
following procedure.
When using the GY-DV500 as playback component
1.
Turn ON both units.
2.
Confirm that the VCR Setup Menu item No.126 INPUT
SELECT is set to "CAMERA"(cA).
* If set to "IEEE1394", set it to "CAMERA" and then turn
ON the power again.
3.
Insert the videocassette.
4.
Connect the DV cable.
Memo:
When the GY-DV500 is controlled through the DV
connector, set the VCR Setup Menu item No.050
REMOTE SELECT to "IEEE1394".
However, the following functions may not work
depending on the component that the GY-DV500 is
connected to.
• REC
• FF (FWD search is possible)
• REW (REV search is possible)
Note:
If the above procedure is not performed correctly, the playback picture may be disturbed or the sound may fall out. If this
happens, redo the connection by performing steps 1. to 4. described above.
64
TALLY
MIC
+48V
ON
DV cable
Video component with DV Connector
DV connector
When using the GY-DV500 as recording component
1.
Turn ON both units.
2.
Set the VCR Setup Menu item No.126 INPUT SELECT to
"IEEE1394"(iE).
3.
Insert the videocassette.
4.
Connect the DV cable.
Memo:
• When recording while controlling the GY-DV500
through the DV connector from another component
with DV connector, set the VCR Setup Menu item
No.050 REMOTE SELECT to "IEEE1394".
In this case, it takes approximately 2 to 3 seconds
before recording starts on the GY-DV500.
• When video is input through the DV connector, the
EE picture is not displayed in the viewfinder.
When the GY-DV500 is used as camera, and a backup
recording is made on another component via the DV
connector, set the VCR Setup Menu item No.126 INPUT
SELECT to "CAMERA".