Using External Components; Connecting A Video Component With Dv Connector - JVC GY-DV5000 Instructions Manual

9. USING EXTERNAL COMPONENTS

9-1 Connecting a Video Component with DV Connector

Connecting the GY-DV5000 to another video component equipped with DV I/O connector (IEEE1394 standard) using a DV cable
(optional) enables dubbing of digital signals with high picture quality and high-quality sound.
Rear section of GY-DV5000
PHONES DV REAR AUDIO IN TALLY
DC IN
DC OUT
DV connector
DV cable (VC-VDV204 (4P-4P), VC-VDV206 (4P-
6P))
When Using the GY-DV5000 as Playback Unit (Dubbing to Another Video)
EDITSEARCH
MONITOR
FILTER
1 3200K
5600K / ND
2 1 8
.3 5600K
.4 5600K 1 64 / ND
STATUS
SHUTTER
MENU
AUDIO
LEVEL
AUTO IRIS FULL AUTO BLACK LOLUX
CH-1 CH-2
MODE
BACK L STRETCH
VTR
NORMAL NORMAL
SPOT L COMPRESS
CAM
POWER
VTR
ON OFF
MODE switch
● Dubbing still images makes the images coarser. In addition,
noise may appear in the sound.
MEMO:
● The operation methods differ with the characteristics and specifications of the connected equipment. Even if connection is
possible, operation or data communication may sometimes be impossible to perform.
● If block noise appears or the sound falls out, try to disconnect and then connect the DV cable again, or turn the power to the
GY-DV5000 off and then on again.
● When connecting to a D-9 (digital-S) component with an IEEE1394 connection, the date and time data are not output from
the D-9 component. Also, the date and time data cannot be recorded on the D-9 component. When making an IEEE1394
connection with a D-9 component, install SA-DV60 on the device.
● If the power to the component connected to the DV connector is turned on, or the video input is changed, noise may appear
in the audio. When these operations have to be performed, reduce the sound volume of the audio component, speaker, etc.,
connected to the GY-DV5000 to a minimum.
● When using the TC DUPLICATE mode of BR-DV600A, set Menu No. 416 [NON DROP/DROP] of BR-DV600A according to
the framing mode (Drop/Non-drop) of the tape to be played back on this unit.
60
OPEN
MODE
LCD BRIGHT DISPLAY
PULL
OPEN
VTR
FRONT
REAR
CH-1 CH-2
AUDIO INPUT
AUDIO SELECT
CH-1 CH-2
AUTO
MANUAL
CAM
Video component with DV Connector
DV connector
1.
Connect the units with the DV cable.
2.
Turn ON both units.
3.
Place the GY-DV5000 in the VTR MODE.
Press the MODE switch upward to turn on the VTR indicator.
4.
Insert the videocassettes.
GY-DV5000: Insert the recorded videocassette.
Recording unit: Insert the videocassette to be dubbed to.
5.
Press the PLAY button on the GY-DV5000 to start playback.
6.
Start recording on the recording unit.
For details, see the instructions to the unit used for
recording.
7.
When dubbing is completed.
Stop recording on the recording unit, and then press the
STOP button on the GY-DV5000 to stop playback.