Chapter 8
Backing up and restoring CallPilot
Using the CallPilot tools, you can:
•
back up CallPilot information
•
restore CallPilot information
•
retrieve the CallPilot log files
To use these features, you must install the CallPilot Backup and Restore Utility on your computer.
Note: You must have Windows 95 or later installed on your computer to run the CallPilot
Backup and Restore Utility.
Installing the CallPilot Backup and Restore Utility
To install the CallPilot Backup and Restore Utility:
1
Load the CallPilot CD in the CD-ROM drive of your computer.
2
Open the CD folder and open the Optional Software folder.
3
Open the BRU Utility folder.
4
Copy the file CallPilotBRU.exe to a folder on your computer.
5
Remove the CallPilot CD from your computer.
Backing up the CallPilot information
Backing up the CallPilot information is a method of protecting your CallPilot programming, voice
messages and greetings. When you back up CallPilot, you make a copy the CallPilot information
and store it in a directory on your computer. If your CallPilot 100/150 must be replaced or loses its
programming, you can restore this back up information to your CallPilot 100/150.
Note: Nortel Networks recommends that you perform a back up after you have completed
your initial programming. We also recommend that you back up on a regular basis to save
new programming, greetings and voice messages.
You must install the CallPilot Backup and Restore Utility on the computer you are using to
back up the CallPilot information.
CallPilot 100/150 Installation and Maintenance Guide
51